Lanner FW-7582 User Manual download pdf (Page 29)

Bios Settings

Chapter 4

Network Application Platforms

Lan Bypass Function

In this screen, you can configure the Lan Bypass

functionality. The system have 8 LAN ports but only Lan3/4

and Lan5/6 have bypass function. (when facing the front

panel and counting from the left).

Riser Card (or Power on/Runtime) Bypass Control

You can activate or deactivate the Lan Bypass ports. For

the description of the physical ports that are capable of

the LAN Bypass function, refer to the Front Panel Feature in

Chapter 1 Introduction.

SYSOff Bypass Control

You can enable or disable the automatic activation of

hardware Lan Bypass function in the event of a power

failure. Hardware Bypass can automatically activate to

allow network traffic to continue.

The Lan bypass can be turned on or off in two system

states, i.e., power on and power off. The following are the

illustration of the possibilities of LAN bypass configuration

in each state.

Bypass settings

System Status

LAN Bypass for Port1 and

Port 2

LAN Bypass 1&2 when

power o

Power on Enabled Disabled Enabled

Bypass Non-Bypass

Power o Bypass Bypass

Bypass settings

System Status

LAN Bypass for Port1 and

Port 2

LAN Bypass 1&2 when

power o

Power on Enabled Disabled Disabled

Non-Bypass Non-Bypass

Power o Non-Bypass Non-Bypass

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Lanner FW-7582 User Manual Page 29