Lanner FW-7582 User Manual download pdf (Page 11)

Introduction

Chapter 2

Network Application Platforms

Note:

The CPU heat sink could only be installed in only 1.

one direction as shown in the picture.

To protect the CPU socket pins, retain the CPU 2.

cap when the CPU is not installed.

Installing a CompactFlash Card

FW-7582 provides one CompactFlash slot. Follow the

procedures bellow for installing a CompactFlash card.

Align CompactFlash card and the card slot with the 1.

arrow pointing toward the connector.

Push the card to insert into the connector.2.

CPU and the Heat Sink Installation

The FW-7582 sever system is powered by the MB-7582

sever board, which comes with one ZIF type LGA1155 CPU

socket.

Follow the procedures bellow for installing a CPU

Remove the CPU socket cap.1.

Press the load lever and release it from the retention 2.

tab.

Lift the load lever and then the plate.3.

Align the cut-out of the CPU and the the notch on 4.

the socket. The CPU should fit perfectly into the

socket. Note that the CPU fits in the socket in only one

direction.

Close the plate and push the load lever to lock it back 5.

to the retention tab.

Peel off the sticker on the CPU to expose the thermal 6.

compound.

Put the heatsink on the installed CPU, match the 7.

screws with the screw holes on the board. Fasten two

screws which are opposite to each other at a time and

then the other two. It is easier this way because of the

springiness of the bracket.

Place the heatsink cover on top of the installed heatsink 8.

and screw 5 screws to fasten it on the chassis.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

No comments

Lanner FW-7582 User Manual Page 11